Check Microwave Assembly - GE JVM1650BB005 Installation Instructions Manual

Installation Instructions
CHECK MICROWAVE ASSEMBLY
Exhaust Adaptor (absent
on models shipped for
recirculation exhaust)
Back of
,,
• Place the microwave in its upright position, with the
top of the unit facing up.
• The microwave oven may be shipped assembled for
top exhaust (adaptor installed) or for recirculation
exhaust (adaptor absent).
• If the microwave was shipped for recirculafion
exhaust, skip to (;5. If shipped for top exhaust,
proceed with (;4.
ADAPTING MICROWAVE
BLOWER FOR RECIRCULATION
[] Remove . _ Denper [] I,ifl off the
and save , blower plate
screw that and attached
holds blower" adaptor from
plate to the microwave.
microwave. [
Back of
_-- Microwave
"
_ Slide exhaust adaptor to one side and remove it.
NOTE: The exhaust adaptor with damper is not
needed for recirculating models. You may want to
save them for possible furore use.
_ Remove and the that holds the blower
save screw
motor to the microwave.
_ Blower P late
_11_ Backof
€_ _- Microwave
11_
"----. _. Blower M otor
""q_-- Screw
20
_ Careflflly pull out the blower unit. The wires
will extend far enough to allow you to adjust the
blower unit.
_Roll the blower unit 90 ° so that fan blade openings
are facing toward the flont of the microwave.
R011
NOTE: Make sure wires remain routed in the
grooves of the
motor
flame.