Check Microwave Assembly; For Recirculation - GE Over the Range Microwave Oven Installation Instructions Manual

C3.

CHECK MICROWAVE ASSEMBLY

Exhaust Adaptor (absent
on models shipped for
recirculation exhaust)
•
Place the microwave in its upright position, with the
top of the unit facing up.
•
The microwave oven may be shipped assembled for
top exhaust (adaptor installed) or for recirculation
exhaust (adaptor absent).
•
If the microwave was shipped for recirculation
exhaust, skip to C5. If shipped for top exhaust,
proceed with C4.
C4. ADAPTING MICROWAVE
BLOWER FOR RECIRCULATION
Remove
1
and save
screw that
holds
blower
plate to
microwave.
Slide exhaust adaptor to one side and remove it.
3
NOTE: The exhaust adaptor with damper is not
needed for recirculating models. You may want to
save them for possible future use.
Remove and save the screw that holds the blower
4
motor to the microwave.
Installation Instructions
Back of
Microwave
Damper
Lift off the
2
blower plate
and attached
adaptor from
the microwave.
Back of
Microwave
Blower Plate
Back of
Microwave
Blower Motor
Screw
Carefully pull out the blower unit. The wires
5
will extend far enough to allow you to adjust the
blower unit.
Roll the blower unit 90° so that fan blade openings
6
are facing toward the front of the microwave.
BEFORE: Fan Blade
Openings Facing Up
AFTER: Fan Blade
Openings Facing
Forward
NOTE: Make sure wires remain routed in the grooves
of the motor frame.
20
Roll