GE JVM1650BB005 Installation Instructions Manual page 17

Installation Instructions
ADAPTING MICROWAVE
BLOWER FOR OUTSIDE
BACK EXHAUST
_i_ Remove and save screw that holds blower motor
to IIllC Iowave.
BlowerMotor
Backof
Microwave
-_ BlowerMotor
- "_--- Screw
[] Careflllly tile blower unit. Tile wires
pull otlt
will extend far enough to allow you to adjust tile
blower unit.
End
[] Rotate blower unit counterclockwise 180 °.
BeforeRotation After Rotation
Microwave Microwave
[]Gently tile wires flom tile
ielilove
grooves.
Reroute tile wires through grooves on other side
of tile blower unit.
BeforeRerouting After Rerouting
Wires RoutedThroughRightSide Wires RoutedThroughLeft Side
[]Roll tile blower unit 90 ° so that fan blade
openings are facing out tile back of tile
IIli c r owave.
BeforeRolling
Backof
Microwave
After Rolling
I Backof
Microwave
_ Place tile blower unit back into tile opening.
EndA
End
CAUTION: Do not pull or stretch the blower
unit wiring. Make sure the wires are not
pinched.
NOTE: The blower unit exhaust
openings should match exhaust
openmgs on rear of microwave oven.
Secure tile blower unit to tile microwave with
tile screw from Step 1.
1
I
BlowerPlate
Backof
Microwave
BlowerMotor
Screw
_ Replace tile blower in tile plate position
same
as before with tile screw.
17