Electric Dryer Power Hookup - Canada Only - Kenmore 11075202310 Installation Instructions Manual

Installation Spacing
3"
14" max. _ (76 ram)
(356 m m)
f 18"
(457 ram)
5V2"
(140 mm)
(25 ram)
_Required spacing
t
48 in?
(310cm_)
24 in?
(155cm_)
(76 ram)
Installation spacing for recessed area or closet
The dimensions shown are for the minimum spacing allowed.
[] Additional spacing should be considered for ease of installation
and servicing.
[] Additional clearances might be required for wall, door, and floor
moldings.
[] Additional spacing of 1" (25 mm) on all sides of the dryer is
recommended to reduce noise transfer.
[]
[]
For closet installation, with a door, minimum ventilation openings in
the top and bottom of the door are required. Louvered doors with
equivalent ventilation openings are acceptable.
Companion appliance spacing should also be considered.
Mobile home = Additional installation requirements
This dryer is suitable for mobile home installations. The installation must
conform to the Manufactured Home Construction and Safety Standard,
Title 24 CFR, Part 3280 (formerly the Federal Standard for Mobile
Home Construction and Safety, Title 24, HUD Part 280) or the Canadian
Manufactured Home Standard CAN/CSA-Z240 MH.
[] Metal exhaust system hardware, available for purchase. For further
information, please reference the "Assistance or Service" section of
your Use and Care Guide.
[] Special provisions must be made in mobile homes to introduce
outside air into the dryer. The opening (such as a nearby window)
should be at least twice as large as the dryer exhaust opening.
ELECTRIC DRYER POWER
HOOKUP - CANADA ONLY
E[e@rica[ Requiremen%
Electrical Shock Hazard
Plug into a grounded 4 prong outlet.
Failure to do so can result in death or electrical shock.
it is your responsibility:
[] To contact a qualified electrical installer.
[] To be sure that the electrical connection is adequate and in
conformance with the Canadian Electrical Code, C22.1 - latest
edition and all local codes. A copy of the above codes standard
may be obtained from: Canadian Standards Association, 178 Rexdale
Blvd., Toronto, ON M9W 1R3 CANADA.
[] To supply the required 4 wire, single phase, 120/240 volt, 60 Hz.,
AC only electrical supply on a separate 30-amp circuit, fused
on both sides of the line. A time-delay fuse or circuit breaker
is recommended. Connect to an individual branch circuit.
[] This dryer is equipped with a CSA International Certified Power Cord
intended to be plugged into a standard 14-30R wall receptacle. The
cord is 5 ft. (1.52 m) in length. Be sure wall receptacle is within reach
of dryer's final location.
A-wire receptacle (14-30R)
[] Do not use an extension cord.
if using a replacement power supply cord, it is recommended that you
use Power Supply Cord Replacement Part Number 3394208. For further
information, please reference the "Assistance or Service" section of your
Use and Care Guide.
GROUNDING iNSTRUCTiONS
[] For a grounded, cord-connected dryer:
This dryer must be grounded, in the event of malfunction or
breakdown, grounding will reduce the risk of electric shock
by providing a path of least resistance for electric current.
This dryer is equipped with a cord having an equipment-
grounding conductor and a grounding plug. The plug must
be plugged into an appropriate outlet that is properly
installed and grounded in accordance with all local codes
and ordinances.
WARNING:
improper connection of the equipment-
grounding conductor can result in a risk of electric shock.
Check with a qualified electrician or service representative
or personnel if you are in doubt as to whether the dryer is
properly grounded. Do not modify the plug provided with
the dryer: if it will not fit the outlet, have a proper outlet
installed by a qualified electrician.
SAVE THESE INSTRUCTIONS