Assembly - Pro-Form CROSSWALK FIT 415 User Manual

ASSEMBLY
Assembly requires two persons.
Place all parts in a cleared area and remove the
packing materials. Do not dispose of the packing
materials until you finish all assembly steps.
After shipping, there may be an oily substance
on the exterior of the treadmill. This is normal, if
there is an oily substance on the treadmill, wipe
it off with a soft cloth and a mild, non-abrasive
cleaner.
Left parts are marked "L" or "Left" and right parts
are marked "R" or "Right."
To identify small parts, see page 6.
Assembly requires the following tools:
the included hex key
one Phillips screwdriver (_======_
To avoid damaging parts, do not use power tools.
.
Go to www.proformservice.com/
registration on your computer and register
your product.
• activates your warranty
• saves you time if you ever need to contact
Customer Care
• allows us to notify you of upgrades and offers
Note: if you do not have Internet access, call
1-888-533-1333 and register your product.
2. Make sure that the power cord is unplugged.
Remove and discard the two screws (A) and
the shipping bracket (B) from the right side of
the Base (74). Then, remove and discard the
screws and the shipping bracket (not shown)
from the left side of the Base.
Remove the tie securing the Upright Wire (63).
Press a Base Cap (70) into each side of the
Base (74) (only one side is shown).
2 \
7