Pro-Form CROSSWALK FIT 415 User Manual page 8
Hide thumbs
Also See for CROSSWALK FIT 415:
- User manual (32 pages) ,
- Manuel de l'utilisateur (28 pages) ,
- User manual (28 pages)
Table of Contents
Advertisement
.
Identify the Right Upright (76). Have a second
person hold the Right Upright near the Base
(74).
See the inset drawing.
Tie the wire tie in the
Right Upright (76) securely around the end of the
Upright Wire (63). Then, insert the Upright Wire
into the lower end of the Right Upright as you
pull the other end of the wire tie out of the Right
Upright.
3
Wire
6
Tie
76
Wire
.
Lay the Right Upright (76) near the Base (74) as
shown. Attach the ground wire to the Base with a
#8 x 1/2" Ground Screw (1).
Then, press the Upright Grommet (73) into the
square hole in the Right Upright (76).
4
74
_round
Wire
76
73
Square
Hole
8
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the CROSSWALK FIT 415 and is the answer not in the manual?
Questions and answers
Slipping while walking
The Pro-Form CROSSWALK FIT 415 treadmill may be slipping while walking due to an overtightened or improperly tightened walking belt. If the walking belt is too loose or off-center, it can cause performance issues. Adjust the tension of the walking belt using the hex key and ensure it is centered. You should be able to lift each edge of the belt 2–3 inches (5–7 cm) off the walking platform. Additionally, worn components, lack of lubrication, or hardware issues such as a cracked deck or frame could also contribute to the problem.
This answer is automatically generated