Adjusting The Timing Of The Vibrating Presser Foot - Consew 206RBL Instruction Manual

Feeddog
I \
\
I----t--\
..•..
\
"
\
"
\
\,--"
•...
\
'\-.----'"-
8. STANDARD ADJUSTMENTS
8-12. Adjusting the timing of the vibrating presser foot
<Whenthe needlelowers>
'1
Check the vibrating presser foot timing as follows:
,. Lower the presser bar lifter lever, then turn the
pulley toward you. At this time, the vibrating
presser foot should reach the feed dog before the
needle eye does.
2. When the needle is raised, make sure the vibrat-
ing presser foot is still holding the material firmly.
If the vibrating presser foot rises while the needle
is still penetrating to the material, it may cause
skipped stitches, etc.
<Whenthe needleraises>
:1
L~--~-\[t
---
\
liftingpresserloot\ __ ~
\
'-
---_\
-
vibratingpresser
100
t
Needle
Feeddog
- 22 -
If the timing is not correct after you make these ad-
justments:
,. Loosen the two screws
O.
2. To synchronize the timing of the vibrating presser
foot, turn the cam
e.
3. Tighten the screws
O.