Omron F160 Vision Sensor Setup Manual page 55

Maintenance
F150-SL20A/SL50A
Precaution
F150-SLC20/SLC50 or F160-SLC20/SLC50
42
Use the following procedure to replace a Light with the F150-LT10A Light.
(The F150-LT10A cannot be connected to the older F150-S1 Camera.)
Camera base
3
4
Light
1. Disconnect the light cable from the light connector on the back of the Cam-
era.
2. Remove the light cable from the slot in the camera base.
3. Remove the two screws securing the Light.
4. Remove the Light from the Camera.
5. Reverse steps 1 through 4 when installing the Lens and Light.
Do not disassemble the Lens. Disassembly can damage the Lens.
Use the following procedure to replace a Light with an F150-LTC20 (20-mm
field of vision) or F150-LTC50 (50-mm field of vision) Light.
Camera base
2
1
Hold this part when
removing the Cable.
1. Disconnect the light cable from the light connector on the back of the Cam-
era.
2. Remove the light cable from the slot in the camera base.
3. Remove the two screws securing the Light at the top.
4. Remove the two screws securing the Light at the bottom.
2
Hold this part when
removing the Cable.
1
Camera cable
Lighting connector
connector
5
3
4
Section 5-2
Light