Omron F160 Vision Sensor Setup Manual page 17

Installation Precautions
Securing the Video Monitor (When Using the Recommended F150-M09)
1,2,3...
Touching Signal Lines
Removing the Memory Card
Turning OFF the Power
Using the RESET Signal
4
Observe the following precautions to prevent noise interference, because the
video monitor case is connected to the 0V line in the internal circuits.
1. Do not ground the video monitor.
2. Do not ground the metallic part of the connector.
3. Secure the video monitor with plastic screws if it is being mounted to a me-
tallic surface.
To prevent damage from static electricity, use a wrist strap or another device
for preventing electrostatic discharges when touching terminals or signal lines
in connectors.
Before removing a Memory Card, stop the power supply to the Card or turn
OFF the F160. The Memory Card or the F160 itself may be damaged if a
Memory Card is removed while power is being supplied.
(Stop the power supply to the Memory Card from the menu.)
Do not turn OFF the power while a message is being displayed indicating that
processing is being performed. Data in memory will be corrupted, and the
F160 may not operate correctly the next time it is started.
0.Scn 0 MON
Saving data.
Do not use the RESET input immediately after power is turned ON. When
using the RESET input to synchronize startup timing, wait at least 1 second
after the F160's power supply is turned ON before turning ON the RESET sig-
nal.
---- ---ms
Section 1-1