General Safety Precautions - Omron F160 Vision Sensor Setup Manual

General Safety Precautions

1 General Safety Precautions
Battery Precautions
!WARNING
!WARNING
Installation Environment Precautions
!Caution
!Caution
!Caution
!Caution
Power Supply and Wiring Precautions
!Caution
!Caution
!Caution
xii
Do not disassemble the F160, apply pressure to the F160 that would deform
its shape, or incinerate the F160. A lithium battery is built into the F160 and it
may combust, explode, or burn if not treated properly.
Do not short circuit, attempt to charge, disassemble, apply pressure that would
deform, or incinerate the lithium battery. The lithium battery may start a fire,
explode, or burn if not treated properly.
Do not use the F160 in environments with flammable or explosive gases.
Install the F160 away from high-voltage devices and moving machinery to
allow safe access during operation and maintenance.
Do not block the F160's cooling vents.
F 1 6 0
P O W
E R V IS IO
N M A
C O N
R U N T E
T R O
L L E R
E R R
O R
C O N
S O L E
C A M
E R A
0
C A M
E R A
1
M O N
IT O R
+
2 4 V
D C
1 .2 A
-
Before the F160 is shipped, a protective label is attached to the top of the
F160 to cover the cooling vents. This label prevents wire strands from falling
into the F160 during wiring, so it must not be removed until wiring is com-
pleted. The label must be removed after wiring to allow proper cooling during
operation.
Be sure to securely tighten the screws when mounting the F160.
Use the F160 with the power supply voltages specified in this manual.
Use the wire and crimp terminals of the proper sizes as specified in this man-
ual. Do not connect the power supply wires by just twisting stranded wire and
connecting directly to the terminals.
Use a DC power supply with countermeasures against high-voltage spikes
(safe extra low-voltage circuits on the secondary side).
Cooling vents
Cooling vents
1