Extension Roller Adjustment; Adjusting Infeed/Outfeed Rollers - Makita PLANER 2040 Instruction Manual

that the roller arm surface is a t the 90" to
the column.
Fig. 1 1
Adjusting infeed/outfeed rollers
The infeed/outfeed rollers are factory adjusted. If the rollers require adjustment, please
follow this procedure :
Place
a
straight and.lever piece of wood
on
the outfeed table top. Turn the crank handle
to raise the table and to bring the piece of wood into contact with the main frame. Then
turn the crank handle a half-turn counterclockwise to lower the table slightly. Insert the
piece
of
wood so that
it
reaches under the outfeed roller. Adjust the right and left heighi
adjusting screws
so
that
the
outfeed roller contacts the piece of wood evenly.
Adjust the infeed roller in the same manner as the outfeed roller.
NOTE :
Turning the height adjusting screw one turn clockwise lowers the roller 3 mm (1/8").
I