Blade Height Adjustment - Makita 1051D Instruction Manual

CAUTION:
The knob can be turned beyond the 0.5 mm
•
graduation. However, do not operate the tool with a
depth of cut more than 0.5 mm The motor may be
burned out or the battery cartridge may be
damaged.
Switch action
1
002551
CAUTION:
Before inserting the battery cartridge into the tool,
•
always check to see that the switch trigger actuates
properly and returns to the "OFF" position when
released.
To prevent the switch trigger from being accidentally
pulled, a lock-off button is provided.
To start the tool, depress the lock-off button and pull the
switch trigger. Release the switch trigger to stop.
ASSEMBLY
CAUTION:
Always be sure that the tool is switched off and the
•
battery cartridge is removed before carrying out
any work on the tool.
Removing or installing planer blades
CAUTION:
Tighten the blade installation bolts carefully when
•
attaching the blades to the tool. A loose installation
bolt can be dangerous. Always check to see they
are tightened securely.
Handle the blades very carefully. Use gloves or
•
rags to protect your fingers or hands when
removing or installing the blades.
Use only the Makita wrench provided to remove or
•
install the blades. Failure to do so may result in
overtightening or insufficient tightening of the
installation bolts. This could cause an injury.
To remove the blades, first loosen the two installation
bolts one turn counterclockwise with the hex wrench.
1. Lock-off button
2. Switch trigger
2
002557
Push the blade from the belt side with the hex wrench.
Remove the other blade in the same manner.
1
002558
To install the blades, first clean out all chips or foreign
matter adhering to the drum or blades. Insert the blade
between the drum and the drum cover from the side
opposite the belt so that the blade end will protrude
slightly from the side of the drum.
Tighten the two installation bolts securely with the hex
wrench.
1
5
002559

Blade height adjustment

2
002567
Blade height adjustment is usually not necessary.
However, if you notice that the blade edge is below the
level of the rear base or protrudes too far from the rear
base, proceed as follows.
6
1. Installation bolts
1
2. Hex wrench
2
1. Hex wrench
2. Planer blade
2
2 1. Drum cover
2. Installation bolts
3
3. Planer blade
4. Side of drum
5. Drum
4
1. Pan head
1
screws
2. Installation bolts