Ampere Rating
Not
More Than
More Than
0
6
6
10
10
12
1 2
16
Volts
12OV
2 5 f t .
5 0 f t .
1 0 0 f t .
150
ft.
2 4 0 V
5011.
100 ft.
200 ft.
300
ft.
Total length of cord in feet
AWG
1 8
16
16
1 4
18
16
1 4
1 2
16
16
1 4
1 2
1 4
12
Not Recommende
'Only the applicable parts of the Table need to be included. For instance. a 120-volt product need no
I
include the 240-volt headina.
17. REDUCE THE RISK OF UNINTENTIONAL STARTING. Make sure switch
in off position before plugging in.
18. USE RECOMMENDED ACCESSORIES. Consult the owner's manual fc
recommended accessories. The use of improper accessories may cause ris
of injury t o persons.
19.
NEVER STAND ON TOOL. Serious injury could occur if the tool is tipped c
if the cutting tool is accidentally contacted.
20.
CHECK DAMAGED PARTS. Before further use of the tool, a guard or otht
part that is damaged should be carefully checked t o determine that it wi
operate properly and perform its intended function
-
check for alignmer
of moving parts, binding of moving parts, breakage of parts, mounting, an
any other.conditions that may affect its operation. A guard or other part thc
is damaged should be properly repaired or replaced.
21. DIRECTION OF FEED. Feed work into a blade or cutter against the directio
of rotation of the blade or cutter only.
22. NEVER LEAVE TOOL RUNNING UNATTENDED. TURN POWER OFF. Don
leave tool until
it
comes t o a complete stop.
23.
PROPER GROUNDING. This tool should be grounded while in use t o protec
the operator from electric shock.
24. EXTENSION CORDS: Use only three-wire extension cords which have threr
prong grounding-type plugs and three-pole receptacles which accept th
tool's plug. Replace or repair damaged or worn cord immediately.
I