Table of Contents
Advertisement
Appendix I: Workflow layouts
Move Shape Up (↑) or Down (↓): Moves a shape up or down in the list.
The Selected Point section of the Calibration pane provides controls to modify the
properties of a selected point.
Original Position X/Y:
Reset to Current Position:
Current Position X/Y:
Reset to Initial Position:
The Selected Shape panel provides controls to modify the properties of a selected shape.
The points that are part of the shape also show their Point properties.
Name:
Draw Mode:
Manual Blending
Unlike the Reverse Mapping tool, the 2D projector calibration tools—Warping and Edge
Warping—require manual blending. The Blending tool adds blending to the edges of
the selected projector. Blending should be used when more than one projector is display-
ing content in the same region on the surface. Blending allows the seamless and smooth
overlap between two projectors. Manual blending should not be used with Reverse
Mapping, because the Reverse Mapping tool already calculates blending.
Barco Pn: 60600320
You can also use the Del key to delete selected
shapes.
The position of a shape in the list corresponds to its
drawing order.
Sets the position in pixels of the selected point in the
source-camera image.
Sets the current position of the selected point as the
source position in the camera image.
Sets the modified position in pixels of the selected
point.
Reverts the current position of the selected point to
the original position of the selected point.
Name of the shape.
Determines how the shape is drawn and transforms the source image.
• "None" does not transform anything (disables a shape).
• "Move" moves the shape and leaves black where the
shape initially was.
• "Duplicate" copies the shape, leaving the original content
untouched, as opposed to "Move."
• "Mask" draws the shape all black.
Barco Media Server XHD-Series User Guide
179
Advertisement
Table of Contents
