Asko OP8631S Operating Instructions Manual page 44

44
Removing and replacing the oven door with a cam hinge
• Completely open the oven door. Lift the clips of the lower
hinge supports on both sides to the upright position and clip
them to the plug of the upper hinge supports.
• Close the oven door half way and gently pull them out.
Replace the door in the reverse order.
• Insert the door in the half-closed position (angle of
approximately 60°) by pushing them towards the oven while
opening them all the way. Pay attention to the notches on
the lower hinge supports, which should coincide with the
lower edge of the notches on the front side. When the door
is completely opened, remove the clips from the plugs of the
upper hinge supports and return them to horizontal position.
REMOVING AND REPLACING THE OVEN DOOR WITH A
SINGLE-AXIS HINGE (depending on the model)
a) Conventional closing
b) GentleClose – the system absorbs the shock from door
closing. It allows simple, quiet, and smooth closing. A gentle
push (to a 15° angle relative to the closed door position) is
enough for the door to close automatically and softly.
If the force applied to close the door is too strong, the
effect of the GentleClose system is reduced or the
system will be bypassed for safety.
• Fully open the oven door and rotate the stoppers all the way
back – applies to conventional door closing (Figure 1).
fi gure 1
• With GentleClose door system, rotate the stoppers back by
90°(Figure 2).
fi gure 2