After Operation - Kärcher BDS 33/190 C User Instructions

English BDS 33/190 C, BDS 43/150 C, BDP 43/410 C, BDS 43/Duo C Operating instruction
Cleaners:
BDS 33/190 C, BDS 43/150 C, BDP 43/
410 C, BDS 43/Duo C
– pad drive disc + red pad
– CA 748
– CA 747 (wet-look-cleaner)
– pre-spraying unit
Procedure:
■
Insert pad drive disc and attach pad
■
Treat floor, cleaning fluid is sprayed on
with the pre-spraying unit during
cleaning
Polishing:
(coated floorings)
BDP 43/410 C, BDS 43/Duo C (300 rpm)
– Pad drive disc + beige pad
Procedure:
■
Insert pad drive disc and attach pad
■
Polish floor
Sealing:
(only possible to use on chalky stone
floorings)
BDS 33/190 C, BDS 43/150 C
– pad drive disc + sealing pads
– CA 749
– sprayer
– mop
Procedure:
■
Clean floor, neutralise and allow to dry
well
■
Spray approx. 10 m
749 using a sprayer
■
Spread evenly over the floor with the
mop
■
Allow to dry a little
■
Treat the floor with sealing pad until the
surface has a high gloss
2
of floor with CA
■
Repeat the process from step 2 if
necessary until the desired degree of
gloss is achieved.

After operation

Warning!
Comply with statutory regulations on the
disposal of cleaning agent solutions
■
Switch off unit and pull the power plug
■
Wind up the power cable properly
■
Detach cleaning agent tank (accessory)
and dispose of the unused cleaning
agent solution
■
Rinse the cleaning agent tank or pre-
spraying unit (accessory) with clean
water
■
Remove the brush wheel attachment
after use
■
Wash dirty pads at max. 60°C.
23