Starting The Unit - Kärcher BDS 33/190 C User Instructions

English BDS 33/190 C, BDS 43/150 C, BDP 43/410 C, BDS 43/Duo C Operating instruction
Warning!
When in operation, the unit must at all
times be kept moving!
Do not keep the unit working on one spot,
since this can cause damage to the floor
covering!

Starting the unit

Connect to the mains
– Only work with dry hands
– The mains voltage must correspond to
the voltage given on the rating plate
For connected loads see -Technical
Specifications-
Caution!
When using the devices
BDS 43/150 C, BDP 43/410 C and
BDS 43/Duo C with built-on suction unit
(accessory) the maximum permissible
mains impedance of the electrical
connecting point (see technical
specifications) may not be exceeded.
■
Insert power plug
■
Place the handle in the working position
by pulling the lever (1)
Note:
Handle positioned approximately at waist
height
■
Press the catch (2) (either left or right)
inwards
■
Pull up the switch on the same side (3)
– The brush wheel attachment turns
Note:
By releasing the switch (3) the brush wheel
attachment stops
Increase speed
(only BDS 43/Duo C)
■
Press the button (4) with the unit
running
– The brush wheel attachment turns at
higher speed
Note:
The speed cannot be increased until 3
seconds after switching on the unit.
Reduce the speed by releasing the
switch (3) and turning back on
19