Uniden GSHC1000 Series Owner's Manual page 16

App Cam 25
The App Cam 25 is included in the GSHC 3000 (Outdoor/
Indoor Kit) and does NOT come paired to the Gateway.
Connecting to the Gateway
Follow the steps below to pair the App Cam 25 to the
Gateway.
camera DID.
4. Tap if search didn't produce any result and you would like to manually
enter DID (15 characters). (DID can be found on the back of camera).
5. Please name your camera and specify the location where the camera will be
installed. The camera default Security Code is '123456'. Tap
pairing the camera to the Gateway.
16
1. First connect the antenna to the
camera. Then connect the camera
to the Wi-Fi router via the Ethernet
cable supplied.
2. Connect the antenna and power
on the camera using the AC adaptor supplied.
After about 45 seconds, the red LED is steady
on and the green LED begins to flash (3-flash/
pause pattern), indicating that the camera is in
Pairing mode. and wait until both the LEDs glow
steady.
3. Launch the 'Guardian Home' App, select the
Gateway, tap
to add new camera to the Gateway.
Tap Tap the App will now search for the camera the App will now search for the camera
connected to the Wifi router and pull in the
in the 'Status' section and tap
to complete