Taking Out Discs - Epson PP-1002 User Manual

Taking out discs

When the publishing process finishes, follow the steps below to take out published discs.
For PP-100II/PP-100/PP-100AP
The stacker used as the output stacker differs depending on the publish mode. Confirm the output stacker in the
following table.
Publish Mode
Standard mode
(when the output stacker is set to Stacker 2)
Standard mode
(when the output stacker is set to Stacker 4)
External Output mode
(when the output stacker is set to Stacker 3)
External Output mode
(when the output stacker is set to Stacker 4)
Batch mode
1
Only when the output stacker is Stacker 2 or Stacker 3, open the disc cover and take it out.
For precautions when you open the disc cover, see
2
Take out the published discs from the stacker.
<Stacker 2>
• After printing on the label surface, allow EPSON specified CDs/DVDs to dry for at least
one hour, and other types of discs for at least 24 hours. Do not insert discs into a drive or
other device until they are completely dry.
• Avoid drying under direct sunlight.
• Directly touching or moisture getting on the label surface before or after printing may
result in blurring or discs sticking together.
Output Stacker
Stacker 2
Stacker 4
Stacker 3
Stacker 4
Stacker 2
Stacker 3
"Opening the Disc Cover" on page
<Stacker 3>
Publishing Discs
Number of Discs
Up to approximately 50 discs
Up to approximately 5 discs
Up to approximately 50 discs
Up to approximately 5 discs
Up to approximately 50 discs
Up to approximately 50 discs
21.
<Stacker 4>
71