Epson PP-1002 User Manual page 70

7 Configure each setting.
See "Print Settings area" on page 46
8
Click Print.
EPSON Total Disc Utility starts, and the disc publishing process begins.
• With the PP-100II, PP-100, or PP-100AP , you can take out the published discs output to
Stacker 4 without pausing the job. However, when the BUSY light is flashing rapidly, do
not pull out Stacker 4 because discs are being output to Stacker 4. Doing so may
damage the discs.
• Once the output stacker becomes full, the job is paused. The job is resumed
automatically if you take out the published discs and close the disc cover/stacker 4.
• If the Mac shuts down while processing a job, all the jobs are cancelled.
• For PP-100II/PP-100
∗ Do not open the disc cover while a job is being processed (while the BUSY light is
∗ If a job is being processed (while the BUSY light is flashing) and you need to open the
∗ If you open the disc cover while a job is being processed (while the BUSY light is
∗ While an alarm beep is sounding, the arm is moving. To ensure safety, do not put your
• For PP-100AP
∗ If you open the disc cover while a job is being processed (while the BUSY light is
∗ If you open the disc cover while a job is being processed (while the BUSY light is
• For PP-50
∗ If you open the disc cover while a job is being processed (while the BUSY light is
∗ If you open the disc cover while a job is being processed (while the BUSY light is
70
for details.
flashing). This could adversely affect the writing or printing quality.
disc cover to load or take out discs, first pause the job and then open the disc cover.
See "Pausing/Cancelling Jobs" on page 73
flashing), an alarm beep sounds and the current job enters the standby status.
Closing the disc cover automatically resumes the job.
hands inside the product. Also, do not operate any stackers while an alarm beep is
sounding. This could damage the arm.
flashing), make sure the internal light has turned off and that the arm has stopped
moving before performing any operation, such as loading or taking out discs. Do not
put your hands inside the product or operate any stackers while the arm is moving.
Also, open and close the disc cover gently.
flashing), the current job enters the standby status. Closing the disc cover
automatically resumes the job.
flashing), make sure the internal light has turned off and that the arm has stopped
moving before performing any operation, such as loading or taking out discs. Do not
put your hands inside the product or operate any stackers while the arm is moving.
Also, open and close the disc cover gently.
flashing), the current job enters the standby status. Closing the disc cover
automatically resumes the job.
for the procedure to pause a job.