When Discs Cannot Be Published - Epson PP-1002 User Manual

When Discs Cannot be Published

If the disc is not published by clicking Publish in the Publish view of EPSON Total Disc Maker, or if the product does
not work, check the points below.
Check 1: Check of EPSON Total Disc Utility
Is an error message displayed in EPSON Total Disc Utility?
Check the status of this connected product in EPSON Total Disc Utility, and perform the remedy if an error has
occurred.
See the references below for details on EPSON Total Disc Utility.
•
"EPSON Total Disc Utility" on page
• EPSON Total Disc Utility Help
Check 2: Check of the product
Is the power light turned on?
If the power light is not turned on, the power for the product is turned off.
Turn on the power by referring to
Is the ERROR light flashing or turned on?
If the ERROR light is flashing or turned on, an error has occurred in this product.
See "Checking Lights for Errors" on page 114
Check 3: Check of connection between the product and PC
Is the USB cable disconnected?
Check that the USB cable is connected. Also, check that the USB cable does not have a broken wire or is bent.
Is the USB cable compatible with the PC and product specifications?
If you use USB cable other than one supplied with the product, check that it is compatible with the specifications.
See "Interfaces" on page 149
ATI South Bridge chip set IPX460 or earlier is incompatible with the product.
Are you using a USB hub?
The USB cable should be connected directly between the PC and the product.
39.
"Power/Control Panel Problems" on page 108 in this
for the error checking and remedy procedures.
for the interface specifications.
Troubleshooting
guide.
123