Related Manuals for Christie 38-804785-01
Summary of Contents for Christie 38-804785-01
- Page 1 I N S T A L L A T I O N M A N U A L Universal flat-panel mount www.christiedigital.com PM ©2004/ REV 02...
- Page 2 The installation instructions should be read, understood and followed to prevent personal injury or property damage. Keep these installation instructions in an easily accessible location for future reference. Indicates that the power plug is to be disconnected from Contact Christie for any questions the power outlet. Safety precautions must be taken at all times.
- Page 3 Assembly drawing Dimensions are in Inches 24.000 20.000 15.317 1.411 Ø0.406 7.690 7.100 11.000 15.500 14.200 7.100 4.375 Ø2.375 Description A. Wall plate 5.058 4.905 B. Mounting brackets 2.964 C. Griplate™ D. Mounting hardware E. M6 x 30 (mm) Phillip screws F.
- Page 4 Parts list (con’t) All of these parts are used to install the mounting bracket. Make sure that none of these parts are missing before beginning installation. If there are parts missing stop the installation and contact Chritie. Level (1) Griplates™ (4) M6 x 12 Safety knobs (2) Wall plate (1) 5/16"...
- Page 5 Installing the adapter plate WARNING : Proper installation procedure by qualified personnel as outlined in the installation instructions must be adhered to. Failure to do so could result in serious personal injury and possible damage to the flat panel. WARNING! INVERT THE FLAT PANEL AND PLACE IT ON A SOFT, FLAT SUFRACE TO PREVENT DAMAGE TO THE FLAT PANEL.
- Page 6 Horizontal or Vertical mounting To mount your flat panel horizontally, secure the two (2) mounting brackets to the adapter by securing them with the four (4) grip plates and four (4) M5 X 12 phillip head screws. Place the grip nipples facing down on the bottom of the mounting bracket and facing up on the top.
- Page 7 Finding the wood studs behind the wall structure Using a (commercially available) wood stud finder, locate Wood stud finder (commercially available) the 16" stud centers behind the wall. Once found, make a pencil marking on the center of the wood studs. See figure 4.
- Page 8 Securing the wall bracket to the wall Drill six (6) ¼" pilot holes to the marked wall. See figure 6. 16" Drill gun (6) Pilot holes Level and secure the plate to the wall with the reference arrow facing up to the ceiling. Secure the plate using the six (6) 5/16"...
- Page 9 Securing the flat panel to the wall mount WARNING: AT LEAST (2) QUALIFIED PERSONNEL ARE STRONGLY RECOMMENDED FOR INSTALLATION OF THIS PRODUCT. FAILURE TO DO SO COULD RESULT IN SERIOUS INJURY AND POSSIBLE DAMAGE TO THE FLAT PANEL. Raise the flat panel with the LEFT and RIGHT mounting brackets secured to the flat panel and insert the top and bottom hooks from each bracket to the rods from the wall plates.
- Page 10 Securing the flat panel to the wall mount Tilt the flat panel and secure the two (2) M6 x 12(mm) safety knobs to each of the mounting brackets. See figure 10 M6 x 12 Safety knobs NOTE: To remove the display from the wall simply extend the display to its maximum tilt range, remove the two 6 (mm) safety knurl knobs push the flat panel back to it’s flat position loosen or remove the two (2) M6 x 30 lateral shift screws and lift the unit of the wall.
- Page 11 - 11 -...
- Page 12 www.christiedigital.com PM©2004 - 12 -...
Need help?
Do you have a question about the 38-804785-01 and is the answer not in the manual?
Questions and answers