Related Manuals for Christie 38-817001-01 Series
Summary of Contents for Christie 38-817001-01 Series
- Page 1 INSTALLATION MANUAL 38-817001-01 SERIES PROJECTOR MOUNT BASE BOX ASSEMBLY -20RL Christie Digital Systems 10550 Camden Drive Cypress, CA 90630 Phone: (866) 880-4462 Fax: (714) 503-3385 www.christiedigital.com...
- Page 2 Page 2 Installation Manual...
-
Page 3: Table Of Contents
Installation Tools ..............................5 Base Box Assemblies.............................. 6 Ceiling Installation – 20RL............................. 7 Pipe Extender and Pipe Reducer..........................9 Troubleshooting Procedures ..........................10 Technical Specifications ............................11 Warranty ................................12 Contact Christie Digital Systems .......................... 12 Notes ..................................13 Installation Manual Page 3... -
Page 4: Warning Statements
MUST BE READ TO PREVENT PERSONAL INJURY AND PROPERTY DAMAGE. KEEP THESE INSTALLATION INSTRUCTIONS IN AN EASILY ACCESSIBLE LOCATION FOR FUTURE REFERENCE. Indicates that the power plug is to be Contact Christie Digital Systems with any disconnected from the power outlet. questions. Safety precautions must be taken at all times. -
Page 5: Parts List
This mount is shipped with all proper installation hardware and components. Make sure that none of these parts are missing and/or damaged before beginning installation. If there are parts missing and/or damaged, please stop the installation and contact Christie Digital Systems (800-221-8025). Security Crush... -
Page 6: Base Box Assemblies
Base Box Assembly Base Box Assemblies The installation instructions should be fully read and understood, including all of the safety symbols and safety precautions, before beginning installation, to prevent personal injury or property damage. Keep these installation instructions in an easily accessible location for future reference. All base boxes feature the following adjustments to facilitate ease of installation: Tilt of ±6°... -
Page 7: Ceiling Installation - 20Rl
Base Box Assembly Ceiling Installation – 20RL Separate the upper bridge from the base box by removing the six (6) M5 x 12 mm screws that are located on the base box, three on each side (A). Secure the top bridge to the ceiling structure at this time (see warning label) using commercially available hardware (B). - Page 8 Base Box Assembly Loosely install the hinge pin screws, flat washer and conical spacer to each side of the base box. Slide the conical spacer and the flat washer to the back of the screws. Raise the 38-817001-01 mounting bracket and attach to the projector’s chassis and insert the hinge- pins through the hinge-pin openings.
-
Page 9: Pipe Extender And Pipe Reducer
(refer to its installations). Refer to the 38-817001-01 series installations instructions at this time. Install the jam screw all the way up to the end of the threads of the threaded pipe extender or 1½"... -
Page 10: Troubleshooting Procedures
Base Box Assembly Troubleshooting Procedures QUESTION: My projector mount must be set at an angle to be viewed properly on the wall, but the projector will not hold at this position. Why is this? ANSWER: The angle adjustments are not tight; they must be tightened. QUESTION: Why won’t my bracket fit my projector? ANSWER:... -
Page 11: Technical Specifications
Base Box Assembly Technical Specifications All measurements are inches (mm). Figure 6. Technical Dimensions Installation Manual Page 11... -
Page 12: Warranty
Warranty Limited Lifetime Warranty All Christie Digital Systems products carry a limited lifetime warranty from ship date against defects in materials and workmanship. Christie Digital Systems is not liable for improper installation that results in damage to mounts, adapters, display equipment or personal injury. -
Page 13: Notes
Base Box Assembly Notes ©Christie Digital Systems2004 Installation Manual Page 13...