Driver Installation With Netware 3.12 - 3Com 3C905-TX User Manual

3 When this has been done, bind the protocol to the
user-assigned names.
When running the 3C59X.LAN driver with NetWare 3.11, you
must update the MONITOR.NLM file that accompanied
NetWare 3.11 with the MONITOR.NLM file from Novell. For
the latest NLMs, contact Novell.

Driver Installation with NetWare 3.12

To install the 4.x server driver while running NetWare 3.12,
follow these steps:
1 Copy the contents of the appropriate \NETWARE
subdirectory to the boot partition of the server's hard disk.
2 When you start the server, enter the following commands:
load C:3C59X.LAN PORT=XXXX NAME=X [Enter]
load C:3C59X.LAN PORT=XXXX NAME=Y [Enter]
where XXXX is the adapter's port address. (To determine the
port address, refer to the section "Finding the Adapter's Port
Address" earlier in this chapter.) The NAME=X and NAME=Y
parameters that you assign help distinguish the multiple
adapters.
If the load sequence is not followed, the system will not
operate correctly. Make sure that the PORT=XXXX parameter
is entered for all adapters.
3 When this has been done, bind the protocol to the
user-assigned names.
This concludes the procedure for installing multiple adapters
in a PCI server.
Installing NetWare Drivers 3-11