3-10
C
HAPTER
3 When this has been done, bind the protocol to the driver
as usual.
This concludes the procedure for installing a single adapter in
a PCI server.
Multiple PCI Adapters in a Server
If you are running NetWare and have installed multiple
adapters in a PCI computer that is functioning as a server,
follow the instructions in this section.
The 3C59X EtherDisk diskette contains a NetWare 4.x server
driver (3C59X.LAN) and the NetWare Loadable Modules
(NLMs) that enable the NetWare 4.x driver to be used with
NetWare 3.11 or 3.12 software. These files are found in the
\NETWARE subdirectory.
Driver Installation with NetWare 3.11
To install the 4.x server driver while running NetWare 3.11,
follow these steps:
1 Copy the contents of the appropriate \NETWARE
subdirectory to the boot partition of the server's hard disk.
2 When you start the server, enter the following commands:
load C:LSLENH.NLM [Enter]
load C:3C59X.LAN PORT=XXXX NAME=X [Enter]
load C:3C59X.LAN PORT=XXXX NAME=Y [Enter]
where XXXX is the adapter's port address. (To determine the
port address, refer to the section "Finding the Adapter's Port
Address" earlier in this chapter.) The NAME=X and NAME=Y
parameters that you assign help distinguish the multiple
adapters.
If the load sequence is not followed, the system will not
operate correctly. Make sure that the PORT=XXXX parameter
is entered for all adapters.
3: I
N
NSTALLING
ETWORK
D
RIVERS
Need help?
Do you have a question about the 3C905-TX and is the answer not in the manual?