Multiple Pci Adapters In A Client - 3Com 3C905-TX User Manual

If you experience problems that occur only when using the
AutoLink program, display or print the AUTOLINK.LOG file.
The AUTOLINK.LOG file contains a log of all the events that
occurred during the AutoLink installation and configuration
process.
a To display the file, type:
b To print the file, type:
7 When the auto installation process is finished, remove the
diskette and reboot the computer.
When you do this, the computer will boot as a NetWare
DOS ODI client.
To ensure that your computer is configured with the latest
client software, ask your system administrator to configure a
3Install account on the server. Instructions for configuring a
3Install account are contained in the README.TXT file located
in the \QINSTALL\SERVER directory on the 3C59X EtherDisk
diskette.
This concludes the procedure for installing a single adapter in
a NetWare DOS ODI client using the AutoLink feature.

Multiple PCI Adapters in a Client

If you are running NetWare and you have installed multiple
Fast EtherLink PCI adapters in a PCI computer, follow the
steps below.
Before proceeding, make sure that you have the adapter port
address for each adapter to be installed. Refer to the section
"Finding the Adapter's Port Address" earlier in this chapter.
1 With the main menu displayed (Figure 3-2), select Network
Drivers.
type autolink.log | more
print autolink.log
Installing NetWare Drivers 3-7