One Pci Adapter In A Server - 3Com 3C905-TX User Manual

3-8 C
HAPTER
2 When the Network Drivers screen appears, select Install
Novell NetWare Drivers.
3 When the Novell NetWare Drivers screen appears, select
Copy DOS ODI Client Driver.
A message about PCI adapter backward compatibility
appears, followed by instructions to specify a target drive.
The default drive is C:\NWCLIENT.
If you are running an ODI driver with multiple adapters
already installed and you have not updated the NET.CFG file,
the following message appears:
NetWare DOS ODI client Multiple EtherLink XX
Adapters found.
Use NET.CFG to specify I/O Port.
Specify which adapter you want the driver to recognize by
adding the I/O port address to the NET.CFG file using the
PORT= XXXX parameter. The 3C59X EtherDisk diskette
contains a sample NET.CFG file in the \NETWARE directory.
This concludes the procedure for installing multiple adapters
in a PCI client.

One PCI Adapter in a Server

If you are running NetWare and have installed a single
adapter in a PCI computer that is functioning as a server,
follow the instructions in this section.
Before proceeding, make sure that you have the adapter port
address for the adapter to be installed. Refer to the section
"Finding the Adapter's Port Address" earlier in this chapter.
The 3C59X EtherDisk diskette contains a NetWare 4.x server
driver (3C59X.LAN) and the NetWare Loadable Modules
(NLMs) that enable the NetWare 4.x driver to be used with
NetWare 3.11 or 3.12 software. These files are found in the
\NETWARE subdirectory.
3: I N
NSTALLING ETWORK
D
RIVERS