Programming; To Add A Remote Control, Keyless Entry, Or Myq; Control Panel) - Raynor Premium series 8500RGD Prodigy II Owner's Manual

Programming

Your hand-held remote control (model 893RGX) has already been programmed to the door control (MyQ
Below are instructions for programming additional remote controls, keyless entries, and MyQ
NOTE: Use the learn button on the door control to program all accessories. The yellow learn button on the garage door opener will NOT
program accessories.

To Add a Remote Control, Keyless Entry, or MyQ

®
Control (MyQ

Control Panel)

REMOTE CONTROL 1. Press the MyQ
2. Press the button on the remote control
3. The garage door opener lights will flash
MyQ ® ENABLED
ACCESSORIES
1. Press the MyQ ® Control Panel
LEARN button twice, the red learn
LED will turn on.
2. Press the LEARN button on the
MyQ ® device.*
LEARN
Button
Model 825LM - Remote Light Control
Light module can be synchronized with the
garage door opener light bulbs.
®
Control Panel LEARN
button twice, the red learn LED will
turn on.
that you wish to operate your garage
door.
(or two clicks will be heard) when the
code has been programmed.
Model 829LM - Garage Door and Gate Monitor
Indicates the status of your garage door from inside
the home and allows you to close an open garage door
from inside the house.
®
®
Enabled Accessories using the Door
KEYLESS ENTRY
1. Press the MyQ ® Control Panel LEARN button twice, the red learn
LED will turn on.
2. Enter a 4-digit personal identification number (PIN) of your choice
on the keyless entry keypad. Then press the ENTER button.
3. The garage door opener lights will flash (or two clicks will be
heard) when the code has been programmed.
Command
LED (yellow)
Learn
LED
(Red)
LEARN
Button
26
® Control Panel) at the factory.
enabled accessories to the door control.
? ?
PIN
Model 823LM - Remote Light Switch
Light module can be synchronized with
the garage door opener light bulbs.
* MyQ ® accessories may be programmed to the
MyQ ® Internet Gateway (Model 828LG) or the
MyQ ® control panel. For instructions on
programming to the internet gateway refer to
the manual.
? ?
LEARN
Button