Table of Contents
Advertisement
Programming
893RGX Remote Control
Your remote control has been programmed at the factory to operate with your garage
door opener. If the remote does not work or you would like to program additional
devices, follow the programming steps below.
Up to 40 Security+ 2.0
®
remote controls can be programmed to the garage door opener.
Older Raynor remote controls are NOT compatible, see page 36 for compatible
accessories. Programming can be done through the door control or the learn button
on the garage door opener. To program additional accessories refer to the instructions
provided with the accessory or visit Raynor.com. If your vehicle is equipped with a
Homelink
®
, you may require an external adapter depending on the make, model, and year
of your vehicle. Visit www.homelink.com for additional information.
TO ADD, REPROGRAM, OR CHANGE A 893RGX REMOTE CONTROL/877LG
KEYLESS ENTRY PIN USING THE DOOR CONTROL
1.
Press the navigation button below "MENU" to view the Features menu.
2.
Use the navigation buttons to scroll to "PROGRAM".
3.
Select "REMOTE" or "KEYPAD" to program from the program menu.
4.
Remote Control: Press the button on the remote control that you wish to operate
your garage door.
Keyless Entry: Enter a 4-digit personal identifi cation number (PIN) of your choice on
the keyless entry keypad. Then press the ENTER button.
The garage door opener lights will fl ash (or two clicks will be heard) when the code has
been programmed. Repeat the steps above for programming additional remote controls
or keyless entry devices. If programming is unsuccessful, program the remote using the
learn button.
1
4
PROGRAM A 893RGX REMOTE CONTROL USING THE LEARN BUTTON ON
THE GARAGE DOOR OPENER
1.
Press and hold the program button on the remote control until the LED on the front
of the remote control turns on.
2.
Press and release the remote control button you wish to use and then press any
other button to exit programming.
3.
Press and release the Learn button on the garage door opener. The Learn LED will
light. Within 30 seconds...
4.
Press the remote control button programmed in step 2 until the garage door opener
light fl ashes or two clicks are heard.
1
Visor
Clip
To program other types of remote controls or keyless entries see the instructions included with the device or visit Raynor.com.
2
Press
to continue.
OR
2
3
3
Press
to continue.
?
?
?
?
PIN
LEARN
Button
LEARN LED
28
4
Advertisement
Table of Contents
Troubleshooting
