Programming; To Add Or Reprogram A Hand-Held Remote Control; To Erase All Codes; 3-Button Remotes - Raynor ULTRA 3595RGDS 3/4 HP Owner's Manual

PROGRAMMING

NOTICE: If this S
AFETY
measure in the receiver of the garage door opener, which provides security against code-theft devices, will be
circumvented. The owner of the copyright in the garage door opener does not authorize the purchaser or supplier of the
non-rolling code transmitter to circumvent that technical measure.
Your garage door opener has already been programmed at the factory to operate with your hand-held remote control.
The door will open and close when you press the large push button.
Below are instructions for programming your opener to operate with additional S

To Add or Reprogram a Hand-held Remote Control

USING THE "LEARN" BUTTON
1. Press and release the "Learn" button
on the motor unit. The learn indicator
light will glow steadily for 30 seconds.
2. Within 30 seconds, press and hold the
button on the hand-held remote
you wish to operate your garage door.
3. Release the button when the motor
unit lights blink. It has learned the
code. If light bulbs are not installed,
two clicks will be heard.
To Erase All Codes From Motor Unit
To deactivate any unwanted remote, first
erase all codes:
Press and hold the "learn" button on motor
unit until the learn indicator light goes out
(approximately 6 seconds). All previous
codes are now erased. Reprogram each remote or keyless
entry you wish to use.
TM
S garage door opener is operated with a non-rolling code transmitter, the technical
IGNAL
* that
Memory
AFETY
USING THE DOOR CONTROL
1. Press the PROG <Learn> button on the
Door Control.
2. Press the PROG <Learn> button again
to confirm Learn Mode.
3. Press the button on the hand-held
remote* that you wish to operate your
garage door.
4. When the motor unit lights blink, it has
learned the code. If light bulbs are not
installed, two clicks will be heard.

*3-Button Remotes

If provided with your garage door opener, the large button
is factory programmed to operate it. Additional buttons on
S S TM
any
AFETY IGNAL
3-Button remote or
compact remote can be
programmed to operate
other S S
AFETY IGNAL
garage door openers.
29
S TM remote controls.
IGNAL
TM