Table of Contents
Advertisement
PREMIUM Series
Belt Drive Wi-Fi
®
Garage Door Opener
Model 8355WRGD - 1/2 hp
FOR RESIDENTIAL USE ONLY
■ Please read this manual and the enclosed safety materials carefully!
■ Fasten the manual near the garage door after installation.
■ The door WILL NOT CLOSE unless the Protector System
aligned.
■ Periodic checks of the garage door opener are required to ensure safe operation.
■ This garage door opener is ONLY compatible with myQ
accessories.
■ DO NOT install on a one-piece door if using devices or features providing unattended
close. Unattended devices and features are to be used ONLY with sectional doors.
■ Attach warning labels to the location indicated on label.
SERIAL NUMBER:
Please write the myQ Serial number in the box above. See page 2.
Register online at: http://blog.raynor.com/warranty-registration
®
is connected and properly
®
and Security+ 2.0
®
CONTENTS
Preparation . . . . . . . . . . . . . . . . . . . 2-5
Assembly . . . . . . . . . . . . . . . . . . . . 6-7
Installation . . . . . . . . . . . . . . . . . . .8-15
Install the Door Control . . . . . . . . . .16-17
®
. . . . . .18-21
Power. . . . . . . . . . . . . . . . . . . . . .22-23
Adjustments . . . . . . . . . . . . . . . . .24-26
Operation . . . . . . . . . . . . . . . . . . .27-33
Connect With Your Smartphone . . . . 29
Maintenance . . . . . . . . . . . . . . . . . . . 34
Troubleshooting. . . . . . . . . . . . . . .35-36
Accessories. . . . . . . . . . . . . . . . . . . . 37
Warranty. . . . . . . . . . . . . . . . . . . . . . 38
Safety & Maintenance Guide . . . . . .39-40
Repair Parts . . . . . . . . . . . . . . . . .41-42
www.raynor.com
Raynor Garage Doors
1101 E. River Road
Dixon, Illinois 61021
Advertisement
Table of Contents
Related Manuals for Raynor Aviator II PREMIUM Series
Summary of Contents for Raynor Aviator II PREMIUM Series
-
Page 1: Table Of Contents
Unattended devices and features are to be used ONLY with sectional doors. ■ Attach warning labels to the location indicated on label. SERIAL NUMBER: Please write the myQ Serial number in the box above. See page 2. Register online at: http://blog.raynor.com/warranty-registration www.raynor.com Raynor Garage Doors 1101 E. River Road... -
Page 2: Preparation
Preparation ® Serial Number Safety Symbol and Signal Word Review Write down the following information for future reference: This garage door opener has been designed and tested to offer safe service provided it is installed, operated, maintained and tested in strict accordance with the instructions and warnings contained in ®... - Page 3 Preparation Before You Connect with Your Smartphone Check the Door Monitor and control your garage door from anywhere using the myQ app. You will need: Wi-Fi enabled smartphone, tablet or laptop Broadband Internet Connection To prevent possible SERIOUS INJURY or DEATH: Wi-Fi signal in the garage (2.4 Ghz, 802.11b/g/n required) ALWAYS call a trained door systems technician if garage door binds, sticks, or is out of Password for your home network (router's main account, not guest network) balance.
- Page 4 5/32 3/16 7/16 5/16 7/16 9/16...
- Page 5 Provided Not Provided...
-
Page 6: Assembly
HARDWARE Washered Bolt 5/16"-18x1/2" Lock Nut Hex Screw #8x3/8" (Mounted in the garage (Mounted in the (Packed with the door opener) garage door opener) sprocket cover) Hex Screw #8x3/8" Washered Bolt 5/16"-18x1/2" Lock... - Page 7 (To motor unit) Spring Trolley Nut Nut ring slot Nut Ring Nut Ring BEFORE AFTER RELEASE 1" 1-1/4" (2.5 cm) (3.18 cm)
- Page 9 OPTIONAL Unfinished CEILING Ceiling MOUNT FOR HEADER Header Wall BRACKET Vertical Centerline of Garage Door Structural Supports Level (Optional) Header Wall 2" (5 cm) Track Highest Point of Travel Door Sectional door with curved track...
- Page 10 HARDWARE Lag Screw 5/16"-9x1-5/8" Header (Finished Ceiling) Bracket Ceiling Mounting Holes 6" (15 cm) Maximum Door Spring (Header Wall) Vertical Vertical Centerline of Centerline of Wall Mount Garage Door Garage Door 2x4 Structural Lag Screw Header Support 5/16"-9 x 1-5/8" Bracket Lag Screw (Header Wall)
- Page 11 HARDWARE Clevis Pin 5/16" x 2-3/4" Ring Fastener Ring Fastener Clevis Pin Connected Disconnected 5/16" X 2-3/4"...
- Page 12 HARDWARE Lock Washer 5/16" Hex Bolt 5/16"- 18x7/8" Nut 5/16"-18 FIGURE 2 FIGURE 1 Unfinished Ceiling Finished Ceiling Not Provided (Not Provided) FIGURE 3 Lag Screws 5/16"- 18x1-7/8" Measure Distance Hex Bolt 5/16"- 18x7/8", Lock Washer 5/16", Nut 5/16"-18...
- Page 13 Trolley Release Arm...
- Page 14 HARDWARE Self-Threading Screw 1/4"-14 x 5/8" FIGURE 2 FIGURE 1 Vertical Reinforcement Vertical Reinforcement Vertical Centerline Vertical Centerline of Garage Door of Garage Door Bolt 5/16"-18 x 2" (Not provided) Door Bracket Lock Washer 5/16" Door Bracket Self-Threading Screw 1/4"-14 x 5/8" Nut 5/16"-18 FIGURE 3 FIGURE 4...
- Page 15 HARDWARE Clevis Pin 5/16" x 1-1/4" Hex Bolt 5/16"-18 x 7/8" Lock Washer 5/16" Clevis Pin 5/16" x 1" Ring Fastener Nut 5/16"-18 CORRECT INCORRECT Straight Straight Curved Door Door Arm Curved Door Door (Groove facing out) Ring Fastener Nut 5/16"-18 Clevis Pin 5/16"...
-
Page 16: Install The Door Control
2 Smart Control Panels or 4 of any other Security+ 2.0 door controls. Drywall Anchor NOTE: Older Raynor door controls and third party products are not compatible. 6-32 x 1" Install door control within sight of garage door, out of reach of small children at a minimum height of 6AB x 1"... - Page 17 HARDWARE HARDWARE Insulated Staple (Not Shown) Clevis Pin 5/16" x 2-3/4" Ring Fastener Ring Fastener 7/16" (11 mm) Clevis Pin Staple 5/16" X 2-3/4"...
-
Page 18: Install The Protector System
Safety Reversing Sensor Safety Reversing Sensor 6" (15 cm) max. above floor 6" (15 cm) max. above floor Invisible Light Beam Protection Area... - Page 19 HARDWARE Carriage Bolt Wing Nut 1/4"-20 x 1/2" 1/4"-20 (Not provided) (Not provided) No more than 6 inches (15 cm) No more Wing Nut than 6 inches 1/4"-20 (15 cm) Carriage Bolt Wing Nut Carriage Bolt 1/4"-20 x 1/2" 1/4"-20 Lens 1/4"-20 x 1/2"...
- Page 20 HARDWARE Insulated Staple (Not Shown) (Not provided) Staple Wing Nut 1/4"-20 Carriage Bolt 7/16" (11 mm) 1/4"-20 x 1/2"...
- Page 21 Pre-installed Safety reversing wires 7/16" sensor wires (11 mm) Not Provided Safety reversing Pre-installed wires sensor wires Yellow (for example) White Purple (for example) White/Black Yellow Purple (for example) (for example) Yellow Purple 7/16" (11 mm) To insert or remove the wires from the terminal, push in the tab with a screwdriver tip.
-
Page 22: Power
TYPICAL WIRING PERMANENT WIRING Ground Tab Green Ground Black Wire Screw Ground Wire Black White Wire Wire... - Page 23 If the receiving sensor is in direct sunlight, switch it with sending sensor so it is on the opposite side of the door. (invisible light beam) Green LED Amber LED SENDING SENSOR RECEIVING SENSOR...
-
Page 24: Adjustments
PROGRAMMING BUTTONS UP Button Adjustment Button DOWN Button DOWN (Close) UP (Open) - Page 25 PROGRAMMING BUTTONS UP Button Adjustment Button DOWN Button...
-
Page 28: Operation
Operation Features LIGHTS Your garage door opener is equipped with features to provide you with greater control over your The garage door opener light bulbs will turn on when the opener is initially plugged in; power is garage door operation. restored after interruption, or when the garage door opener is activated. -
Page 29: Connect With Your Smartphone
Operation Connect With Your Smartphone Learn The Wi-Fi Garage Door Opener is compatible with up to 16 myQ enabled accessories. Up to 10 devices Button can be paired to the Wi-Fi garage door opener’s internal gateway. These devices can be controlled with the myQ app. - Page 30 Operation Using the Door Control The following features are accessible by lifting up the push bar: LEARN A DEVICE SYNCHRONIZE THE DOOR CONTROL ® Any compatible remote controls, wireless keyless entry, Wi-Fi garage door openers, or myQ To synchronize the door control to the garage door opener, press the push bar until the garage door accessories can be programmed to the garage door opener by pressing the LEARN button on the door opener activates (it may take up to 3 presses).
- Page 31 Command LED Command LED LOCK Button LIGHT Button Service LOCK Button LEARN Button LIGHT Button...
- Page 32 LEARN Button LEARN LED LEARN button Command LED...
- Page 33 Operation To Erase the Memory To Open the Door Manually ERASE ALL REMOTE CONTROLS AND KEYLESS ENTRIES 1. Press and hold the LEARN button on garage door opener until the learn LED goes out (approximately 6 seconds). All remote control and keyless entry codes are now erased. To prevent possible SERIOUS INJURY or DEATH from a falling garage door: Reprogram any accessory you wish to use.
-
Page 34: Maintenance
Maintenance Maintenance Schedule The Remote Control Battery EVERY MONTH Manually operate door. If it is unbalanced or binding, call a trained door systems technician. Check to be sure door opens and closes fully. Adjust if necessary, see page 25. Test the safety reversal system. Adjust if necessary, see page 26. To prevent possible SERIOUS INJURY or DEATH: NEVER allow small children near batteries. -
Page 36: Troubleshooting
Troubleshooting DIAGNOSTIC CODE SYMPTOM SOLUTION Up Arrow Flash(es) Down Arrow Flash(es) Door is moving stops or reverses. Manually open and close the door. Check for binding or obstructions, such as a broken spring or door lock, correct as needed. If the door is binding or sticking contact a trained door systems technician. If door is not binding or sticking attempt to reprogram travel (refer to page 25). -
Page 37: Accessories
Accessories MAX ACCESSORIES myQ ACCESSORIES STANDARD ACCESSORIES Compatible with Raynor ® garage door openers manufactured since 1993. 823LM Remote Light Switch: 825LM Remote Light Control: 041A5281-1 Extension Brackets: Automatically control your Automatically control your (Optional) For safety reversing 877MGX MAX Wireless Keyless Entry:... -
Page 39: Automatic Garage Door Opener Safety & Maintenance Guide
Automatic Garage Door Opener Safety & Maintenance Guide Garage Door Opener Safety – An Automatic Decision A garage door is the largest moving object in the home. An improperly adjusted garage door and opener can exert deadly force when the door closes – which could lead to entrapment of children or adults and subsequent injury or death. - Page 40 Routine Maintenance Can Prevent Tragedies Make monthly inspection and testing of your garage door and opener system a part of your regular routine. Review your owner’s manual for both the door and door opener. If you don’t have the owner’s manuals, contact the manufacturer(s) and request a copy for your specifi c model(s). Look for the opener model number on the back of the power unit. WARNING –...
-
Page 41: Repair Parts
Repair Parts Rail Assembly Parts Installation Parts Description Part Number Description Part Number Belt - for 7 foot door 041A5434-11A Curved Door Arm 041B0035B Belt - for 8 foot door 041A5434-13A Door Bracket with Clevis 041A5047-1 Pin and Fastener Belt - for 10 foot door 041A5434-14A Emergency Release Rope 041A2828... - Page 42 Logic Board End Panel 041D8198 Not Shown Terminal Block 041A3150 Contact Information Address repair parts order to: For installation and service RAYNOR ® GARAGE DOORS information call: 1101 East River Road 1-800-472-9667 Dixon, IL 61021-0048 Or visit us online at: www.raynor.com...
- Page 43 Notes...
- Page 44 Wi-Fi ® is a registered trademark of Wi-Fi Alliance. © 2018, LiftMaster 114-5278 All Rights Reserved...
Need help?
Do you have a question about the Aviator II PREMIUM Series and is the answer not in the manual?
Questions and answers
Door will not lift. Motor runs. Open door will close properly
A possible cause is that the trolley is disconnected. If the door does not lift while the motor runs but closes properly, the emergency release handle may have been pulled, disconnecting the trolley. To reconnect, pull the handle straight down to disengage the lockout feature, then operate the door using the control or remote to reconnect the trolley.
This answer is automatically generated