OSEE LM-150 SERIES User Manual page 16

AUD1R, AUD2L, AUD2R. You can select the audio mode mentioned above by pressing the
button "UP, DOWN".
3. When the input signal is VGA and DVI-D, no audio mode can be selected.

METER1R: the same as METER1L.

METER2L: the same as METER1L.

METER2R: the same as METER1L.

COMPO LEVEL : Component Level
Note: Only when input signal is YPBPR: 480I60, this menu can be displayed on the screen. At this
point, the modes of LEVEL are: SMPTE, BETA0, BETA7.5. When you press MENU button to
select this menu, you can select the mode mentioned above by pressing the button "UP, DOWN".
For any other signal formats, its default format is SMPTE and can not be adjusted.
Component Level Definitions are as follows:
BETA7.5
SETUP 53.37mV
714.29 mV
Y
（Peak Luma,100% White）
700.00 mVp-p
(75% Color Bars)
PB/PR
933.34 mVp-p
(100% Color Bars)
SYNC -286 mV

COLOR TEMP : Switch Color Temperature of DVI or VGA signal
From this menu, you can switch color temperature between D93, D56 and D65. When you press
MENU button to select COLOR TEMP menu, you can select the mode mentioned above by
pressing the button "UP, DOWN".

ASPECT : Aspect Ratio Set-up
From this menu, you can set the picture aspect ratio from 4:3 and 16:9 for SD signal format.
1. Press the MENU button to select this menu;
2. Press the button "UP, DOWN" to set the aspect ratio from 4:3 and 16:9.
Note: The menu is not valid for VGA and DVI-D. VGA and DVI-D always set to 4:3.

CC: Set the closed caption
From this menu, you can switch the closed caption between <OFF>，<CC1>，<CC2>，<CC3>，
<CC4>，<TEXT1>，<TEXT2>，<TEXT3>，<TEXT4>，<XDS>.
When you press MENU button to select COLOR TEMP menu, you can select the mode mentioned
above by pressing the button "UP, DOWN".
Note: 1. The menu is only valid for the LM-150V-Z，LM-150S-Z LCD monitor.
The menu is not valid for the LM-150V-D，LM-150S-D LCD monitor.
2. CC only can be used for VIDEO: NTSC and Y/C: NTSC input signal.

UMD CHAR : UMD Character Set-up
From this menu, you can set the display UMD character.
1. Press the MENU button to select this function;
2. Press the ENTER button to select the position of edited character where the cursor will locate.
LM-150 SERIES LCD MONITOR
0mV
700.00 mV
（Peak Luma,100% White）
525.00 mVp-p
(75% Color Bars)
700.00 mVp-p
(100% Color Bars)
-300 mV
SMPTE
0mV
714.30 mV
（Peak Luma,100% White）
756.80 mVp-p
(75% Color Bars)
1009.0 mVp-p
(100% Color Bars)
-286 mV
Operating Manual
BETA0
—12—