Usb Connectivity - Brother PR650e Operation Manual

EMBROIDERING TUTORIAL
■ Getting false thread breakage error
- Check that the position of the upper thread is
under the upper thread guide plates. (Refer to
page 56.)
- Check that the position of the upper thread is
around the thread tension disc. (Refer to
page 57.)
1 Upper thread guide plates
2 Thread tension disc
■ Thread tension changed suddenly
- Thread is caught on a rough edge of the spool
of upper thread.
- Upper thread is caught under the spool of
thread.
- The thread dust or lint is gathered under the
bobbin's tension spring.
■ The frame came out from the carriage
Make sure that the positioning pins are placed
into the frame's positioning slot and hole. (Refer
to page 49.)
To insure proper registration of pattern for
embroidery, turning off the machine and turning
it back on will allow the embroidery arm to reset
it's registration points.
■ Cancel the current design and start again
Select the "Home" key on the upper right of the
screen. The pattern and all information will be
deleted. (Refer to page 70.)
80
— — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —

USB connectivity

You can perform many functions using the USB
ports on the machine. Connect the appropriate
devices according to the feature of each ports.
1 Primary (top) USB port for media or card
Reader/USB card writer module* (USB2.0)
* If you have purchased the PE-DESIGN Ver5 or
later, PE-DESIGN Lite or PED-BASIC, you can
plug the included USB card writer module into
the machine as an embroidery card reader, and
recall patterns.
2 USB port for mouse (USB1.1)
3 USB port for computer
Note
● The processing speed may vary by port
selection and quantity of data.
● Do not insert anything other than USB
media into the USB media port.
Otherwise, the USB media drive may be
damaged.
■ Using USB media or embroidery card Reader/
USB card writer module*
When sending or reading patterns using the USB
media or the embroidery card Reader/USB card
writer module*, connect the device to the
primary (top) USB port.
The primary (top) USB port processes the data
faster than the other ports.
* If you have purchased the PE-DESIGN Ver5 or
later, PE-DESIGN Lite or PED-BASIC, you can
plug the included USB card writer module into
the machine as an embroidery card reader, and
recall patterns.