Table of Contents
Advertisement
— — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —
APPENDIX
Upgrading Your Machine's Software Using USB Media
You can use USB media and a computer to download software upgrades for your sewing machine.
When an upgrade program is available on our website at " http://solutions.brother.com ", please
download the file(s) following the instructions on the website and steps listed below.
Note
When using USB media to upgrade the software, check that no data other than the upgrade file is saved
on the USB media being used before starting to upgrade.
Upgrade file can be recalled from a USB flash drive (USB flash memory) of any size.
Memo
When the machine's software is upgraded, saved combinations of character and decorative stitches are
erased. However, saved embroidery patterns are not erased.
a
Press and hold the
turning on the machine.
The following screen appears.
b
Insert the USB media into the USB port on the
machine. The media device should only
contain the upgrade file.
a USB port for media
b USB media
206
(Settings key) while
Note
When using USB media equipped with an
access indicator, the access indicator will
begin flashing after the media is inserted into
your computer or machine, and may take
about 5 to 6 seconds before the media is
recognized. (The length of time differs
depending on the USB media.)
c
Press
.
The following screen appears.
Note
If an error occurred, a text error message will
appear. At this time, turn the machine off, and
then start the procedure again from step
d
When the following screen appears, upgrading
is completed.
Remove the USB media, and turn the machine
e
off and on again.
a
.
Advertisement
Table of Contents
