Brother PR650e Operation Manual page 237

— — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —
a Pull the ends of the cap out from the center
to remove any slack.
b Use the clips to secure the cap.
1 Clips
• Repeat steps
remove any slack and secure the cap with
the clips.
c Pull the brim holder up as far as possible.
Next, turn the brim holder over the cap
brim, and then lower the brim holder.
1 Brim holder
2 Centerline of brim holder
• Fully lower the brim holder so that the
centerline on the brim holder is visible.
a b
and on the other side to
d Adjust the brim so that it maintains a
rounded shape.
This completes the positioning of the cap
in the cap frame.
e Remove the cap frame from the mounting
jig.
Press both right and left holders on the
mounting jig with both thumbs, and then pull
off the embroidery frame, as shown in the
illustration.
1 Holder
Using the Optional Cap Frame 235
7