Brother PR650e Operation Manual page 232

APPENDIX — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —
6 Lightly press down the ring, and then use the
Allen screwdriver (large) to tighten the four
hexagonal screws on the inside of the ring.
Firmly tighten the screws.
1 Ring
CAUTION
●
Make sure that each hexagonal screw is
firmly tightened. If any screw remains
loosen, injuries may result.
Remove the pad inserted in step
7
■ Installing the needle plate spacer
Attach the needle plate spacer to the needle
plate.
1 Needle plate spacer
230
■ Preparing the mounting jig
Lower the stopper, and then attach the mounting
jig to a stable surface, such as a desk.
1 Use a Phillips screwdriver to loosen the two
screws, and then lower the stopper in the
direction of the arrow.
1 Loosen the screw so that the stopper can be
2 Loosen until the stopper moves.
3 Stopper
2 Tighten the two screws.
5
.
• Make sure that the stopper is firmly
Attach the mounting jig to a stable mounting
surface, such as a desk.
3 Loosen the thumb screw for the mounting jig
to open the mounting bracket so that it is
wider than the thickness of the mounting
surface.
• The mounting bracket can be mounted
hooked onto the screw and clamped with it.
secured.
onto a mounting surface with a thickness
from 9 mm (3/8 inch) to 38 mm (1-1/2
inches).