Verifying The Hardware Installation - Cisco WAP351 Quick Start Manual

Verifying the Hardware Installation

5
To verify the hardware installation, complete the following tasks:
• Check the cable connections.
• Check the state of the indicator lights.
Label Activity
Front Panel
POWER Off
Solid Green
Solid Blue
Solid Amber
Solid Red
Flashing
(Green/Blue/
Amber)
WLAN Off
Solid Green
Solid Amber
Solid Blue
Flashing
PSE Off
Solid Green
Back Panel
LAN1/PD, Off
LAN2/
Solid Green
PSE, and
Solid Amber
LAN3-5
Flashing
If you need help resolving a problem, visit the Cisco Support
N
OTE
Community at www.cisco.com/go/smallbizsupport.
6
Description
The Cisco WAP351 has no power.
The Cisco WAP351 is powered on, booting, or
in normal operation with DC power supply.
The Cisco WAP351 is powered on, booting, or
in normal operation with PoE 802.at power
supply.
The Cisco WAP351 is powered on, booting, or
in normal operation with PoE 802.af power
supply.
The Cisco WAP351 fails to boot with both
firmware images.
The Cisco WAP351 is upgrading the firmware,
or is acquiring an IPv4 or IPv6 address.
Wireless is disabled for both 2.4 GHz and 5
GHz.
Wireless is enabled in concurrent mode
enabled. (The intensity needs to be the same.)
Wireless is enabled with only 5 GHz in use.
Wireless is enabled with only 2.4 GHz in use.
Transmitting or receiving data.
PSE is not in use.
PSE is in use.
No Ethernet link.
Gigabit Ethernet link is active.
Fast Ethernet link is active.
Transmitting or receiving data.
Cisco WAP351 Quick Start Guide