Connecting The Equipment; Verifying The Hardware Installation - Cisco AP541N Quick Start Manual

REVIEW DRAFT — CISCO CONFIDENTIAL
4

Connecting the Equipment

This section describes the process for connecting the device to power
and the network.
Attach the power cord to the power connector and outlet (if used).
S 1
TEP
Connect a network Ethernet cable to the access point Ethernet
S 2
TEP
port.
Connect the other end of the Ethernet cable to your network or the
S 3
TEP
Ethernet port of the PC you are using to configure the access point.
DHCP is enabled by default. If a DHCP server is running on your
W
ARNING
network and you have not turned DHCP off, the device will
accept a new IP address when it is connected to your network.
You must use this IP address to configure the device.
5
Verifying the Hardware
Installation
To verify the hardware installation, complete the following tasks:
• Check the cable connections.
• Check the LED states, as described in
AP541N, page
If you need help resolving a problem, visit the Cisco Small
N
OTE
Business Support Community at
smallbizsupport. For technical documentation and other links, see
Where to Go From Here, page
8 Cisco AP541N Dual-band Single-radio Access Point Quick Start Guide
3.
Getting to Know the Cisco
www.cisco.com/go/
14.