Verifying The Hardware Installation - Cisco Wap581 Quick Start Manual

WAP581 bundles the two Ethernet ports to be link
N
OTE
aggregation mode. If the two Ethernet ports have been connected
at the same time, the link partner must also support link
aggregation.
After installation, all lights should be active. Refer to
Hardware Installation

Verifying the Hardware Installation

5
To verify the hardware installation, complete the following tasks:
• Check the cable connections.
• Check the state of the indicator lights
Label
Power
Ethernet: Left-
Green
Ethernet No.0:
Right-Green
Ethernet No.1:
Right-Green
If you need help resolving a problem, visit the Cisco Support
N
OTE
Community at www.cisco.com/go/smallbizsupport.
Cisco WAP581 Wireless Access Point
for details about the different lights on each switch.
Activity
Off
Solid (Green)
Flashing (Green) The device is booting.
Solid (Blue)
Flashing (Blue)
Solid (Red)
Flashing cycle
with Green and
Blue
Off
Solid Green
Flashing Green Transmitting or receiving data.
Off
Solid Green
Off
Solid Green
Description
The WAP581 is out of power.
The Cisco WAP581 is normal; no wireless
client connected.
The Cisco WAP581 is normal; at least one
wireless client connected.
The Cisco WAP581 is upgrading the
firmware.
The Cisco WAP581 fails to boot with both
firmware images.
Indicates the availability of new firmware
updates for the hardware that can be
downloaded from Cisco.com
No Ethernet link.
Ethernet link is active.
Gigabit Ethernet Link is active
2.5Gigabit Ethernet Link is active
Fast Ethernet Link is active
Gigabit Ethernet Link is active
Verifying the
6