Verifying The Hardware Installation - Cisco WAP125 Quick Start Manual

The system provides a one-time-only access to configure the
N
OTE
access point using a wireless connection.
This wireless default configuration will not allow traffic between WiFi and
Ethernet; users will need to go through the setup wizard to resume the
traffic between WiFi and Ethernet.
To connect the Cisco WAP125 to the network on a wireless mode:
Use wireless clients to locate the WAP125's SSID (CiscoSB-Setup).
S 1
TEP
Use the 'cisco123' passkey to access the access point.
S 2
TEP
After installation, all lights should be active. Refer to
Hardware Installation
WAP125.

Verifying the Hardware Installation

5
To verify the hardware installation, complete the following tasks:
• Check the cable connections.
• Check the state of the indicator light.
Label Activity
Off
Power
Solid Green
Solid Blue
Solid Red
Flashing Green The Cisco WAP125 is booting.
Flashing Blue
Ethernet: Off
Solid Green
Left-Green
Flashing Green Transmitting or receiving data.
Ethernet: Off
Right-Green Solid Green
If you need help resolving a problem, visit the Cisco Support
N
OTE
Community at www.cisco.com/go/smallbizsupport.
Cisco WAP125 Quick Start Guide
for details about the different lights on the Cisco
Description
The WAP125 is out of power.
The Cisco WAP125 is normal; no wireless
client connected.
The Cisco WAP125 is normal; at least one
wireless client connected.
The Cisco WAP125 fails to boot with both
firmware images.
Firmware upgrade is in progress.
No Ethernet link.
Ethernet link is active.
Fast Ethernet link is active.
Gigabit Ethernet link is active.
Verifying the
5