Ricoh SP 311SFNw Getting Started Manual page 13

Note:
For NETGEAR routers, adding a WPS client (such as a printer) is performed through the
•
[ADVANCED] tab  [WPS Wizard], as shown below.
f. Follow screen prompts to enter Client's (printer's) PIN, i.e., number you wrote down in step 1f.
3. On printer, press [Connect]. Display reads, PIN Executing....
4. When printer display reads, Connection to AP has Succeeded,
press [Exit]  [Clear/Stop].
Note:
If the connection succeeds, an IP address has been assigned to the printer. To confirm, see
•
Appendix B: Print Configuration
If the connection fails, Connection to AP has Failed appears on the display, press [Exit] and
•
repeat from step 1. If the problem persists, contact 1-800-RICOH38 (742-6438), option #1.
5. Router web page should indicate, for example, "The wireless client [xyz] has been added to the
network successfully." Click [Logout].
6. Turn printer power switch Off. Wait a moment, and then turn On.
7. Check wireless connection status.
Display should read, Connected. To exit, press [Clear/Stop].
Note:
Also see Appendix A: Check Wi-Fi Connection
•
8. Next, install Network Printer/Scanner Drivers. See
RICOH SP 311SFNw B&W Multifunction Laser Printer
Report.
Press [User Tools] [Network Settings]

Status.
3.2 Network Quick
Getting Started Guide
[Wi-Fi] [Wi-Fi Status].
 
Install.
13