Maintaining Your Tools - Renovator Multi-Tool Safety And Operating Manual

HINTS FOR USING THE RENOVATOR
• Avoid using The Renovator for prolonged periods, especially
whilst a very low speed is set. If The Renovator becomes too
hot, switch The Renovator off. This should cool the motor.
• Always keep the blades sharp.
• Ensure the work piece is secured firmly or clamped to prevent
movement.
• Even slight movement of the material can affect the finish of the
cutting or sanding.
• Start and stop The Renovator whilst clear of the work piece.
• Remember to fit a sanding sheet before starting to sand.
• Do not allow the sandpaper to wear right through, it will damage
the delta sanding pad. Our guarantee does not cover sanding
pad wear and tear.
• When sanding rough surfaces use a coarse grit, medium grit for
smooth surfaces and fine grit for the finishing surfaces. Use a
scrap piece of material to test for the correct sanding coarseness
you need if you are in doubt.
• Excessive pressure will reduce the performance of The
Renovator and may cause the motor to overload.
• Replacing the attachment tools regularly will maintain optimum
performance.
MAINTAIN TOOLS WITH CARE
Remove the power cord from the power socket before carrying
out any servicing, adjustments or maintenance to The Renovator
or attached accessories.
The Renovator requires no additional lubrication or maintenance.
There are no user serviceable parts in The Renovator.
Never use liquids or chemicals to clean your power tool. Wipe
with a clean, dry cloth.
Always store The Renovator in a safe, dry place.
Keep the motor ventilation slots and controls clear of dust and
other debris.
Sparks may occasionally be seen through the ventilation slots.
This is normal and will not damage your power tool.
If the power supply cord is damaged, you must have it replaced
immediately by the manufacturer or an approved service agent
or similarly qualified persons.
35