Renovator Multi-Tool Safety And Operating Manual page 27

USING THE E-CUT SAW BLADES
Application 1: Under cutting skirting board for new flooring
• Select high oscillation frequency.
• Distribute the use of the saw blade evenly to maximise the life of the
saw blades.
1
Using the back side of the new
flooring as a guide, make a cut to
the appropriate length. (1)
3
Clear the space of any debris . (3)
Application 2: Cutting a section of skirting
1
Using one half of the blade edge to
start the cut beginning from the top of
the skirting. Try not to sink the whole
blade edge into the wood, leaving the
other half of the blade edge above the
surface will keep you in control. (1-3)
4
Remove the off-cut. (4-5)
Remove the offcuts. (2)
Slide the new flooring into place.
(4)
• Select high oscillation frequency.
• Setting the blade on a 45
allow room for cutting the full height
of the skirting.
2
27
2
4
3
5
o
angle