Connecting The Vacuum Accessory - Renovator Multi-Tool Safety And Operating Manual

Connecting the
Vacuum Accessory
Typical Application:
of dust and debris.
REMOVE ATTACHMENTS
1
ALIGN VACUUM NOZZLE
2
ATTACH NOZZLE CLIP
3
SELECT HOSE CONNECTOR
4
ATTACH HOSE CONNECTOR
5
ATTACH VACUUM HOSE
6
use with any tool accessory that may produce a lot
Remove any attachments from
the oscillating head. (1)
Insert the slotted end of the
vacuum head into the slotted
end of the vacuum nozzle.
They should clip together.
Then place the vacuum head
opening over the tool holding
head of the Renovator. Make
sure the curved side of the
vacuum nozzle aligns along
the handle of the Renovator.
The curved surface of the
vacuum nozzle and the curved
surface of the Renovator
handle should fit together. (2)
Use the vacuum nozzle clip to
secure the nozzle firmly and
correctly. The clip should snap
into the vent slots on either
side of the Renovator body. (3)
Select the appropriate sized
hose connector and slide on
to the back end of the vacuum
nozzle. Check the connector
grips the nozzle firmly. (4,5)
Attach a vacuum hose to the
hose to nozzle connector. Note
for the best fit it is best to join a
hose directly to the connector.
(6)
Tool accessories can only be
attached to the Renovator
after the vacuum attachment
is securely in place. Some
vacuum hoses have different
sizes so we recommend
using an o-ring seal or tape to
ensure a firm fit.
19