• If the product is class l (earthed), connect the
green / yellow lead to the earth terminal.
Warning! If your product is class ll double
insulated (only 2 wires in the cord set), no
connection is to be made to the earth terminal.
Follow the ﬁtting instructions supplied with good
Any replacement fuse must be of the same
rating as the original fuse supplied with the
Your Box fan comes already assembled
therefore no assembly is required.
Ensure that the voltage rating on the base plate
corresponds to the main voltage at your home.
Remove all packaging from the parts of the fan.
Warning! Never use the fan without the guards
in place or if the guards are damaged.
Switching on and off
Your Fan has a three speed control to keep the
desired air ﬂow through your room.
• To switch on, turn the On/off control knob (1)
to the desired speed. The fan will start.
• To switch off, turn the On/off Control knob
(1)l to the off position.
Adjusting the angle of the fan
The angle of the fan can be adjusted up and
• Loosen the tilt adjustment knobs (4) on each
side of the fan.
• Tilt the body of the fan to the desired angle.
• Re-tighten the tilt adjustment knobs (4) on
each side of the fan.
Your Black & Decker fan has been designed to
operate over a long period of time with a
minimum of maintenance. Continuous
satisfactory operation depends upon proper care
and regular cleaning.
Warning! Before performing any maintenance
or cleaning of the fan, disconnect the appliance
from the power supply.
The main housing should be cleaned with a
clean damp cloth only.
Note: Do not use abrasives or chemical
cleaners on any part of this appliance.
Do not wash any part of this appliance in a
Ventilation slots at the rear of the fan should be
cleaned occasionally with a clean, dry paint
220 – 240 Volts