Table of Contents
Advertisement
Here we take 192.168.13.51 for example as shown below
address of your device according to practical situation. After finishing, please input
the user name and password. Click "OK" button to save the setting.
The default user name and password are "admin" and "123456" respectively.
3.1.2 Directly access through IE
The default network settings are as shown below:
IP address: 192.168.226.201
HTTP:80
Subnet Mask: 255.255.255.0
Data Port:9008
Gateway: 192.168.226.1
The first time you used the IP-Cam, you should connect the device with the above default settings.
Step 1:
Manually setup the IP address of the PC and the network segment should be as the same
as the default settings of IP-CAM. Right click "My Network Places" icon on the desktop. Select
"Properties"as shown in the left figure. Right click "Local Area Connection" at the popup window,
and then select "Property" as shown in the right figure.
Select "Internet Protocol(TCP/IP)" in the "General" tabs. Click "Properties" and input network
address information of the PC in the popup window.
Step 2:
Open the IE Browser and input the default address of IP-CAM and confirm. The IE browser
will download Active X control automatically.
Step 3:
After downloading Active X control, the login dialog box will pop up.
Step 4:
Input user name and password. Click "OK" button to enter into the live interface.
3.2 WAN
Access through the router or virtual server
. Please modify the IP
Step1:
Connecting according to above steps in LAN; Enter into the System Congfig→Network Config
→Port to set up the port number. Please refer to fig 3-1:
Step 2:
Enter into System Config→Network Config→Wired to modify the IP address. Please refer to
fig 3-2:
Step 3:
Enter into the router's management interface through IE browser to forward the IP address and
port of IP-CAM in the "Virtual Server".
Step 4:
Open the IE browser and input its WAN IP and HTTP port to access the IP-CAM. The following
steps are as same as step 3 and 4 of LAN.
Fig 3-1 Port Config
4. NET Traversal Configuration
User can access to network without dynamic domain name and port forwarding by enabling
net transit.
Step 1:
Enter into Config→Network Config→NET traversal Config. Check the "Transit enable". Then
save the setting.
Step 2:
Input
www.upnpipc.com
in IE address bar, download and install Active X control. Then a login
window pops up as shown below:
Step 3:
Input the only device ID of the IP-CAM(the serial number of the device) , user name and password
The default user name and password are "admin" and "123456" respectively.
Fig 3-2 IP Config
Fig 3-3 Router Config
Advertisement
Table of Contents
