Table of Contents
Advertisement
Page 8
download Active X control, please refer to Q4 of chapter 9.
Step 3: After downloading Active X control, the login dialog box will pop up.
Step 4: Input user name and password in the login dialog box and click "OK" button to
enter into the live interface. You can manage and setup the IP-CAM in the IE client,
such as changing IP address, upgrading the software., etc.
3.2 WAN
Access through router or virtual server
Step1: Make sure the device is well connected in LAN. Then enter into System
ConfigurationNetwork configurationBasic configuration to setup the port number
as shown in Fig 3-1:
Step 2: Enter into System ConfigurationNetwork configurationIP configuration
interface to change IP address as shown in Fig 3-2:
Notice: The steps above should be saved after the change of the port and IP address.
Fig 3-1 Port setup
Step 3: Enter into the router‟s management interface through IE browser and forward
the IP address and port of IP-CAM in the "virtual server". The name depends on the
router. Please refer to Fig 3-3:
Step 4: Open the IE browser and input its WAN IP and http port to access. The
following steps are as same as "Step 2, 3 and 4" of Chapter 3.1.2 in LAN.
IP CAMERA USER MUANUAL
Fig 3-3 Router setup
Fig 3-2 IP setup
Advertisement
Table of Contents
