Table of Contents
Advertisement
1. Package
After you receive the device, please check the following accessories. All pictures are only for
reference. Some models can adjust focus. Please take the material object as standard.
2. Connection
MIC
DC12V
LAN
Focus Zoom
Installation Tool
MIC： connect to MIC
DC12V：connect to power supply
LAN：network port; Some models support
PoE power supply
Some models of this series support internal focusing.
The setup steps are as follows:
Step 1: Remove the sun shade and lens case from the
device as shown in the picture on the left.
Step 2: Loosen the screws of the lens for focusing. Then
rotate the lens left or right to adjust the focus.
Focus: Rotate left or right to adjust definition of the image.
Zoom: Rotate left or right to zoom in or out the image.
3. IE Network Connection
User can connect IP-CAM through LAN or WAN. Here only take IE browser(6.0) for example.
The details are as follows:
3.1 LAN
In LAN, there are two ways to access IP-CAM: 1. access through IP-Tool; 2. directly access
through IE browser.
3.1.1 Access through IP-Tool
Step 1:
Make sure the PC and IP-CAM are connected to the LAN and the IP-Tool is installed on the PC
from the CD.
Step 2:
Use IP-Tool to modify the network of IP-CAM. Then double click the
run this software as shown below:
IP-Tool will
automatically
search the device after starting it. If user cannot confirm which one is
yours, please shut off the electricity of the IP-CAM and then power on it. When shutting off
the power, the device information will disappear. When powering on, the device information will
emerge. Well, the device is the used device. User can check the detail information of IP-CAM by
clicking the address of the device as shown below:
Step 3:
Double-click or right- click the IP address and select "browse with IE". Then the system will
pop up the IE browser to connect IP-CAM . IE browser will auto download the Active X control.
After finishing installing the Active X control, a login window will pop up as shown below:
The default user name and password are "admin" and "123456" respectively.
You can also modify the IP address of the device by IP-Tool. Then input the modified IP address
and port in the IE browser bar to access IP-CAM. Right click the device information in the device list
of the IP-Tool to choose network configuration. This will bring up a window as shown below:
For example, the network segment of your computer is 192.168.13.X. Click " Use the following
IP address" and then modify the IP address, gateway of the IP-CAM which must be in the same
network segment with the computer's.
icon on the desktop to
Advertisement
Table of Contents
