Table of Contents
Advertisement
Page 46
IP CAMERA USER MUANUAL
7 Use method for IP-TOOL
Updating through IP-Tool
Note: Do not cut off power supply and internet when updating; If the device is
unable to start because of the failure of upgrade, it needs to retrofit.
First， acquire the IP-Tool from the supplier and then double click the IP-Tool icon
to run this software. Then the device can be searched; if the device can‟t be
searched, please check whether the PC and the device connect to the network or not.
Click the device to check its detail information as shown below:
Network Setup
When upgrading the software and kernel, the IP address of PC and device should be at
the same network segment. If the network segment is different, user should change the
IP address by right clicking the device and then select "network setup".
Modify IP address dialog box will appear as follows:
c
Advertisement
Table of Contents
