Page 18
2. Input port number for IE access in the "HTTP Port" textbox.
3. Input the port number for audio & video transmission in the "Data Port" textbox.
5.4.2
Wired
Enter into "Network Configuration"
There are two options to setup IP: obtain an IP address automatically by DHCP protocol
or manually input IP address and gateway by clicking "Use the following IP address".
PPPoE configuration:
If you want to access through PPPoE, you need to check "PPPoE" and enter username
and password for dial-up internet
PPPOE: User needs to manual input the user name and password for dial-up internet.
Firstly, user needs to login IE clients, then enter into user name and password of PPPoE,
save the setting and exit. Secondly, setup IP address change notice. Thirdly, connect
with Modem, then the device will dial-up internet automatically.
6. Press the "Save" button to save the settings.
5.4.3 NET Traversal Configuration
In this interface, user can access to network without dynamic domain name and port
forwarding by enabling NET transit.
1.Enter into "Network Configuration"
IP CAMERA USER MUANUAL
Fig 5-10 Port Config
"Wired" to see a tab shown as Figure 5-11:
Fig 5-11 Wired Config
"NET traversal Config". Refer to Fig 5-12: